8 bit parallel to serial converter verilog code

I want to give the input in code itself.I dont want to use testbench to give different serial inputs. S <= s end end assign dout = s end end endmodule

The SN74ALS166 shown above is the closest match of an actual part to the previous parallel-in/ serial out shifter figures. After the conversion, the symbol rate will be one-fourth of the original, so set the clock divided by 4 and output it. Concatenation is to assign the low 3 bits signal and the input signal together. This article takes four-bit serial-to-parallel conversion as an example. S <= s end end assign dout = s end else begin always ( posedge (clk ) ) begin //i=3 if (reset ) SN74ALS165 parallel-in/ serial-out 8-bit shift register, asynchronous load CD4014B parallel-in/ serial-out 8-bit shift register, synchronous load SN74LS647 parallel-in/ serial-out 16-bit shift register, synchronous load. Serial to parallel conversion uses shift registers. S <= s end end assign dout = s end else if (i = 2 ) begin //i=2 always ( posedge (clk ) ) begin if (reset ) S <= s end end assign dout = s end else if (i = 1 ) begin //i=1 always ( posedge (clk ) ) begin if (reset ) The output of the shift register block is an 8-bit parallel data and should be updated. The verilog code (2 in one) into a 10-bit format that is transmitted over a serial output Link.

Module trai1enc ( din ,clk ,reset ,dout ) output dout wire dout input din input clk wire clk input reset wire reset reg s initial s = 0 assign din = 1 assign din = 0 assign din = 0 assign din = 1 genvar i for (i = 0 i <= 3 i =i + 1 ) begin if (i = 0 ) begin //i=0 always ( posedge (clk ) ) begin if (reset ) Parallel input serial output shift register verilog code - Shift registers can have both parallel and serial inputs and outputs.

8 bit parallel to serial converter verilog code